Agilent Technologies 85032F, User'S And Service Manual

Page: 10 / 48

1-4 85032F
General Information
Incoming Inspection
Incoming Inspection
Refer to Figure 6-1 on page 6-2 to verify a complete shipment.
Check for damage. The foam-lined storage case provides protection during shipping. If the
case or any device appears damaged, or if the shipment is incomplete, contact Agilent
Technologies. See “Contacting Agilent” on page 5-4. Agilent will arrange for repair or
replacement of incomplete or damaged shipments without waiting for a settlement from
the transportation company. See “Returning a Kit or Device to Agilent” on page 5-3.
Recording the Device Serial Numbers
In addition to the kit serial number, the devices in this kit are individually serialized
(serial numbers are labeled onto the body of each device). For your convenience, the
following table is provided for you to record these serial numbers. Recording the serial
numbers will prevent you from confusing the devices with similar devices.
Clarifying the Terminology of a Connector Interface
In this document and in the prompts of the PNA calibration wizard, the gender of cable
connectors and adapters is referred to in terms of the center conductor. For example, a
connector or device designated as 1.85 mm –f– has a 1.85 mm female center conductor.
8510-series, 872x, and 875x ONLY: In contrast, during a measurement calibration, the
network analyzer softkey menus label a 1.85 mm calibration device with reference to the
sex of the analyzer’s test port connector—not the calibration device connector. For
example, the label
SHORT(F)
refers to the short that is to be connected to the female test
Table 1-1 Kit and Device Serial Number Record
Device Serial Number
Calibration kit
Broadband load –m–
Broadband load –f–
Open –m–
Open –f–
Short –m–
Short –f–
_______________________________
_______________________________
_______________________________
_______________________________
_______________________________
_______________________________
_______________________________