Agilent Technologies 83236B, Operating Manual, Page: 59 / 164

59
Chapter 2, Installation
Load and Run the Connectivity Test Software (Option 001 or 002)
Load and Run the Connectivity Test Software (Option 001 or 002)
The connectivity test is used to verify that the connections between the test
equipment are correct and that the cables are intact. The software also performs
basic functionality checks of each instrument in the Test System.
NOTE: The connectivity test is supplied on the memory card shipped with the Agilent 83236B
option 001, utility software on PCMCIA card, or option 002, utility software on EPSON
memory card. Use the PCMCIA card for the Agilent 8924C or Agilent 8920B; use the
EPSON memory card for the Agilent 8920A or Agilent 8921A.
1 Make proper connections between the Test Set and the PCS Interface.
2 When the PCS Interface is controlled via GPIB Interface, set the GPIB address to 19
on the rear panel of the PCS Interface.
3 When you are testing base stations, make front and rear panel connections shown in fig-
ure 20.
4 To prepare the Test Set for running the connectivity test, perform the steps shown in
figure 21.
5 To load and run the software, follow the steps of figure 22.
NOTE: Use the N(f)-BNC(m) and the N(m)-BNC(f) adapters shipped with the Agilent 83236B
options 001 and 002 when they are required to connect the cables.