34
Chapter 2, Installation
When Used with Agilent 8924C and Controlled via Serial Port for CDMA Subscriber Unit
Tests
When Used with Agilent 8924C and Controlled via Serial Port for CDMA
Subscriber Unit Tests
NOTE:
To control the PCS Interface via the serial port, the firmware of the Agilent 8924C must be
A.05.00 and above. Contact your nearest Agilent Technologies sales office for firmware
upgrade information.
Unpack the PCS
Interface and
Accessories
Follow these steps to prepare the Test System for setup:
1
Unpack the test equipment and accessories.
NOTE:
This product passed all applicable electrical and mechanical inspections before it was
shipped from the factory. As soon as you receive it, check that it is not damaged and that
all accessories are present (see table 2 on page 19). Should this product be damaged or any
accessories be missing, contact your local Agilent Technologies sales office or the
company from which you purchased it.
2
Mount the PCS Interface into the PCS Interface’s option 1AB bench top kit.
3
Place the Agilent 8924C Test Set on the top of the PCS Interface.
Summary of Contents for 83236B
