Agilent Technologies 83236B, Operating Manual, Page: 119 / 164

119
Chapter 4, GPIB Commands
TX Subsystem
TX:OUTPut[:RFANalyzer]:FREQuency?
Returns the frequency of the output signal at the TO ANT IN port. (Query only)
Before executing this command, specify the frequency to be input to the RF IN/
OUT port using the
TX:INP:FREQ
command.
• Response to the Query
{numeric (Hz)} <new line><^END>
NOTE: Use the TX:TSET:FREQ? command which has the functions of both the TX:INP:FREQ
and
TX:OUTP:FREQ?
command.
TX:OUTPut[:RFANalyzer]:LEVel
ëû
< numeric >[DBM]
Specifies the peak level which you want to output to the TO ANT IN port. Use the
TX:OUTP:LEV:ADJ
command to automatically adjust the TX attenuator to
output this signal level from the TO ANT IN port.
<numeric>: − 10 dBm to 0 dBm
If the entered value is out of range, the value is rounded off to the
appropriate limit value.
• Response to the Query
{numeric (dBm)} <new line><^END>
TX:OUTPut[:RFANalyzer]:LEVel:ADJust
Sets the TX attenuator value so that the signal level output to the TO ANT IN port
becomes the level specified by the
TX:OUTP:LEV
command ± 1 dB. (No Query)
This command is valid only when the setting of
RF:PATH
is 1 or 2.