Agilent Technologies 83236B, Operating Manual, Page: 111 / 164

111
Chapter 4, GPIB Commands
RX Subsystem
RX[:RFG1]:OUTPut:LEVel
ëû
< numeric >[DBM]
Specifies the level of the signal which you want to output from the RF IN/OUT or
RF OUT only port.
<numeric> − 130 to − 10 dBm for RF:PATH 1
− 130 to − 20 dBm for RF:PATH 0 and 2
If the entered value is out of range, the value is rounded off to the
appropriate limit value.
• Response to the Query
{numeric (dBm)} <new line><^END>
NOTE: Use the RX:TSET:LEV? command which has the functions of both the RX:OUTP:LEV
and RX:INP:LEV?
command.
RX[:RFG1]:TSET:FREQuency?
ëû
< numeric >[HZ|KHZ|MAHZ|MHZ|GHZ]
Specifies the frequency of the signal which you want to output from the RF IN/
OUT or RF OUT only port, and returns the frequency required at the FROM
DUPLEX OUT port, when the frequency of the wanted signal at the RF IN/OUT
or RF OUT only is specified in
< numeric >
. (Query only)
<numeric>: 800 to 960 MHz, 1710 to 1785 MHz, 1810 to 1910 MHz, or
1930 to 1990 MHz
(The default unit is “Hz”.)
If the entered value is out of range, the value is rounded off to the
appropriate limit value.
• Response to the Query
{numeric (Hz)} <new line><^END>