Agilent Technologies 4288A, Programming Manual, Page: 27 / 289

Chapter 3 25
Setting Up Measurement Conditions and Display
Setting Up Measurement Conditions
3
. S
e
tti
ng u
p
M
eas
ur
em
ent
Con
d
itio
n an
d Di
sp
lay
Selecting measurement range
Selecting measurement range mode
To select the measurement range mode (auto range/hold range), use the following
command.
• :RANG:AUTO on page 185
Selecting measurement range
To select the measurement range, use the following command.
•
:RANG
on page 184
The selectable measurement ranges differ depending on the measurement signal frequency.
Therefore, if a newly selected measurement frequency conflicts with the current
measurement range setting, the setting automatically changes to cover the allowable range.
NOTE Setting up the measurement range automatically sets up the measurement range mode to
the hold range mode.
Selecting measurement time
To select the measurement time (short mode/long mode), use the following command.
•
:APER
on page 130
Selecting cable length
To set the cable length (0 m/1 m/2 m), use the following command.
•
:CAL:CABL
on page 133
Setting up averaging function
Turning ON/OFF averaging function
To turn ON/OFF the averaging function, use the following command.
• :AVER on page 131
Setting up averaging count
To set the averaging count, use the following command.
•
:AVER:COUN
on page 132
Setting up trigger delay time
To set the trigger delay time, use the following command.
•
:TRIG:DEL
on page 195