Agilent Technologies 4156b, User Manual, Page: 408 / 414

8-34 Agilent 4155B/4156B User’s Guide Vol.2, Edition 5
If You Have A Problem
If Errors Occur
337
Cannot set 0.0.0.0 for 4155/4156 IP address.
When a valid host name for the 4155B/4156B network setup is
specified, the IP address of the 4155B/4156B cannot be set to
0.0.0.0
.
338
Cannot set 0(zero) for 4155/4156 User ID.
When a valid host name for the 4155B/4156B network setup is
specified, the User Id of the 4155B/4156B cannot be set to 0 (zero).
339
No response from NFS. Try again ?
There is no response from the Network File System (NFS) when trying
to mount a network disk. Verify the network is operating properly and
the file export executed properly.
340
Host name must be <= 15 alphanumeric character.
The 4155B/4156B host name must be 15 or less alphanumeric
characters.
344
System busy. Cannot execute US/US42 command.
Unable to move to FLEX command control mode, because the
US
or
US42
command cannot be executed while system is busy; making
measurement, operating file functions, executing calibration or
diagnostics, printing, emergency, and so on.
345
Change display page. DISP OFF(0) is not allowed.
Unable to enter the
:DISP OFF
( or
0
) command when the
4155B/4156B screen displays System screen group or KNOB SWEEP
screen.
346
Enter DISP ON(1) to execute this command.
Unable to enter the
:PAGE:KSW
command group,
:PAGE:SCON:KSW
command, or
:DIAG:TEST
test_no ( test_no :
201 to 413) command when the 4155B/4156B screen is set to the
update
disable state by the
:DISP OFF
(or
0
) command.
350
Unable to transfer data. Name buffer full.
Cannot maintain the buffer required for transferring data.
351
File operation was interrupted by system call.
The lpr driver received a signal from the system, which interrupted an
open, read, or write operation.