Agilent Technologies 2110-0457, User Manual

Page: 46 / 212

Chapter 3 Front-Panel Operation and Features
View Menu Operation
45
3
View Menu Operation
From the
View
menu, you can read the Errors, Firmware Revision, and
Calibration String. In addition, you can change the front-panel display mode
to
V-V display
,
I-I display
, or
V-I display
as desired. With this V-V or I-I display
mode setting, you can see voltages or currents on the output1 and the output2,
simultaneously.
• After the display mode is set to V-V or I-I display mode, you can’t change the
limit values. If you attempt to change the limit values by turning the knob
or pressing one of the following keys: , , , , or ,
the front panel display will automatically return to the normal display to
allow you to change the limit values.
• After the display mode is set to V-V or I-I display mode, all the annunciators
remain unchanged.
• To exit the
view
menu without any changes, press key until
NO
CHANGE
is displayed, or select
EXIT
by turning the knob and press
key.
Changing Display Mode
1 Enter the View Menu.
If
ERRORS
appears when you enter the view menu, one or more command
syntax or hardware errors have been detected. Then turn the knob until
DISPLAY
is displayed.
2 Select the display mode you want to display.
Select one of the following display modes by turning the knob:
V-V DISPLAY
,
I-I DISPLAY
, or
V-I DISPLAY
.
3 Save the change and exit the menu.
display
v-I display
<
Current
Voltage
>
Low High
View
View
View
View
View