Agilent Technologies 1670E Series, User Manual

Page: 474 / 650

474
Operator’s Service
Preparing For Use
To inspect the logic analyzer
1 Inspect the shipping container for damage.
If the shipping container or cushioning material is damaged, keep them
until you have checked the contents of the shipment and checked the
instrument mechanically and electrically.
2 Check the supplied accessories.
3 Inspect the product for physical damage.
Check the logic analyzer and the supplied accessories for obvious
physical or mechanical defects. If you find any defects, contact your
nearest Hewlett-Packard Sales Office. Arrangements for repair or
replacement are made, at Hewlett-Packard’s option, without waiting
for a claim settlement.
To apply power
1 Check that the line voltage selector, located on the rear panel, is
on the correct setting and the correct fuse is installed.
See also, "To set the line voltage" on the next page.
2 Connect the power cord to the instrument and to the power
source.
This instrument is equipped with a three-wire power cable. When
connected to an appropriate ac power outlet, this cable grounds the
instrument cabinet. The type of power cable plug shipped with the
instrument depends on the country of destination.
3 Turn on the instrument power switch located on the front panel.