P1512137 R3
41
Do not transport with the over-center handles engaged or damage to the wheel move kit
motors will occur.
Figure 15.
Chain Position
3. Disengage the pump to take the strain off the conveyor drive components.
Ensure that the over-center bolts are tight enough to prevent the handle from engaging. If
they are not tight enough, damage to the gears and motor will result.
5.5. Raising and Lowering
Æ
When equipped with a Hydraulic Lift Cylinder:
The intake hopper must be off the ground when raising and lowering the conveyor.
Before using the hydraulic lift cylinder:
• The hydraulic cylinders are shipped without oil and must be charged with oil before operating the first time.
See the Appendix section for charging instructions.
• Check that the hydraulic hoses are free from leaks, binding, flattening, kinks, or wear.
Raising
1. Before connecting the hydraulic hose, wipe the hose coupler clean.
Dirt in the hydraulic system can damage the cylinder o-rings and can cause leakage and
failure of the system.
2. Connect the hydraulic hoses, ensure the connections are tight. Visually check for leaks, binding, flattening,
kinks, or wear.
3. Open the ball valve on the hose connected to the cylinder.
4. Start tractor and idle at low rpm.
5. Engage hydraulic lever to power the cylinder.
6. Increase tractor rpm until desired rate of lift is reached.
S-DRIVE STANDARD CONVEYOR – PORTABLE GRAIN BELT CONVEYOR