10
P1512181 R0
2.9. Raising and Lowering the Conveyor
• Before raising/lowering/moving/adjusting the conveyor, make sure the area around the
conveyor is clear of obstructions and/or untrained personnel. Never allow anyone to stand
on or beneath the conveyor when it is being placed.
• Lower the conveyor to its lowest position when not in use.
• Empty the conveyor before raising or lowering.
• Do not get on or beneath the conveyor when raising or lowering.
• Raise and lower conveyor on reasonably level ground only.
• Never attempt to increase height of the conveyor by positioning wheels on lumber, blocks,
or by any other means. To do so will result in damage to conveyor and/or serious injury.
• Do not raise the conveyor in high winds.
2.10. Hand Winch Safety
When Equipped:
• Inspect lift cable before using. Replace if frayed or damaged. Make sure lift cable is seated
properly in cable sheaves and cable clamps are secure.
• Tighten brake lock by turning winch handle clockwise at least two clicks after lowering the
conveyor.
• Lower the conveyor fully before towing, then rotate winch handle until cable has light
tension.
• Do not lubricate winch brake discs.
2.11. Positioning the Conveyor
• Transport and place equipment on reasonably level ground when raising, lowering,
positioning, or operating.
• Move the conveyor into position slowly. Do not unhitch and attempt to move by hand.
• Chock wheels and anchor intake end after placement.
2.12. Towing the Conveyor
The conveyor is not intended for transport on public roads. If it requires transport on a public roadway, the
following steps should be taken:
BCX2 FIELD LOADER – PORTABLE GRAIN BELT CONVEYOR
