AgfaPhoto AS 1111, User Manual

Page: 40 / 240

5
EN
Initial Operation
Packing Contents
Photo scanner
Calibration sheet
Cleaning sheet for the feed rollers
Cleaning pen for scanner
Power supply
USB cable
User Manual
User Manual
Missing Package Contents
Connecting power supply
Mains Voltage at the Site of Installation
1 Insert the small plug of the power supply into
the socket on the rear side of your device.
2 Insert the power supply unit into the socket.
Inserting a Memory Card
1 Insert a memory card which is not read-only
into the appropriate card slot at the rear of the
device. Your photo frame supports the follow-
ing memory cards: SD, xD, MMC, MS, CF.
2 Press and hold the
#
key until the control lamp
for the device status is constantly on.
Using the digital photo frame
1 Switch the device off using the on/off switch
on the upper side.
2 Connect the digital photo frame to the Mini-
USB of the device using a USB cable.
3 Switch the device on using the on/off switch.
Notice
Missing Package Contents
If one of the parts is missing or dam-
aged, please contact your retailer or our
customer service.
CAUTION!
Mains Voltage at the Site of Installation!
Check whether the mains voltage of
your device (indicated on the type label)
matches the mains voltage available at
the setup location.
DANGER!
Inserting a Memory Card!
Only use storage media that are com-
patible with the device. In order to
prevent damage to the card or the
unit, please turn off the power before
removing or inserting the card.
Never pull out the memory card while
the device is accessing it. This could
cause data to be damaged or lost.
Notice
Inserting a Memory Card
If both slots are occupied, the data is
saved in the following sequence: SD
(MMC) > CF > xD > MS.
Notice
Control Lamp
If this control lamp flashes, this could
stem from one of the following caus-
es.
- no memory card inserted
- insufficient memory capacity availa-
ble on the memory card (less than
1MB)
- The read-only option of the memory
card is active
- memory card defective
Please note that the initialisation
process of a memory card with a ca-
pacity of 2GB or more takes longer.
The control lamp can blink for up to
20 seconds
Notice
Using the digital photo frame
If the device is connected to a compati-
ble digital photo frame, the scanned
photos can be transferred directly to the
memory of the digital photo frame.
as-1110_1111-manual-03-en-c.book Seite 5 Montag, 29. Juni 2009 10:57 10