AgfaPhoto 799/8029, User Manual

Page: 9 / 26

7
Prepare your camera for use
Lithium battery installation
Please install the lithium battery supplied with the camera before using it according to the following instructions.
1. Slide the battery cover below the camera to access the battery compartment:
Install lithium battery
2. Insert the lithium battery in the correct polarity direction.
3. Then close the battery cover and slide it to lock it in place.
Note:
Please remove the battery if you are not going to use the camera for a while.
Lithium battery charging
To recharge the lithium battery, simply connect the camera (without removing the battery) to your computer using the
USB cable provided in the box. The red LED on the back of the camera will light up to indicate that the battery is
being charged, and will turn off when fully charged. You can also charge the lithium battery by connecting the
camera to AC power if you have an adapter to which you can connect the USB cable.
SD memory card installation
This camera supports SD memory card up to 64 GB (not included). The internal memory can only store a few photos
for test purposes, these photos will be lost when you turn off your camera or remove away the battery. It is
necessary to insert a SD card into the camera before using it. Make sure that the SD card is inserted correctly by
gently sliding it into the slot until it clicks into place to confirm that it is locked. To remove the card, simply press it
firmly and the card will eject itself from the slot.