CAUTION:
Position the digitizer so that it is possible to disconnect the
mains power connection if required.
WARNING:
This device is intended for use by healthcare professionals only.
This device may cause radio interference or may disrupt the
operation of nearby equipment. It may be necessary to take
mitigation measures, such as re-orienting or relocating the
device or shielding the location.
CAUTION:
If you notice conspicuous noise or smoke, disconnect the
digitizer immediately.
CAUTION:
While every care has been taken, it is possible that minor errors
still exist in the product. It is unlikely that a minor error could
result in incorrect (unexpected) device operation.
Related Links
on page 13
General Safety Instructions
• Only service personnel with certified Agfa training must make repairs.
Only authorized service personnel must make changes to the digitizer.
• As is the case for all technical devices, the digitizer must be operated,
cared for and serviced correctly.
• If you do not operate the digitizer correctly or if you do not have it serviced
correctly, Agfa is not liable for resulting disturbances, damages or injuries.
• Do not pour water or any other liquid over the device.
Note
:
The DX-M only supports one type of mammography plates and
cassettes at a time. It has to be decided to use either CR HM5.x or
CR MM3.xR.
• The digitizer complies with the EN60601-1 and UL 60601-1 standards for
Medical Electrical Equipment. This means that, although it is absolutely
safe, patients may not come in direct contact with the equipment.
Therefore the operator console must be placed outside the radius as listed
below around the patient (according to the local valid regulation).
1
2
DX-G, DX-M | Introduction |
49
2321G EN 20181126 1428