Chapter 1 — Preparing the scanner
19
Performing a power-on test
You are now ready to perform a power-on test to check if the scanner is operating correctly.
1.
Check whether you have unlocked the scanner.
2.
Connect the power cable to the scanner.
Make sure that you are using the correct power cable for the voltage in your area. Double-
check whether the voltage indicated on the back panel of the scanner corresponds with the
voltage in your area. If not, call your dealer or Agfa service representative.
3.
Switch on the scanner.
The scanner performs a self-test during which the power indicator light (green) switches on and
the reflective ready indicator light (yellow) and the transparency ready indicator light (yellow)
remain blinking. This takes about half a minute. After the self-test, the three lights switch on.
If a malfunction is detected during the self-test, that is, if the ready indicators remain blinking or
go off, refer to
Appendix A, ‘Troubleshooting’.
4.
Switch off the scanner.
