AGFA Drystar 5300, Reference Manual

Page: 90 / 210

90
2920B EN 20031206
$
If you select “CubicBell”, the following screen will appear, allowing you to
adjust the smoothing factor:
Enter the smoothing factor value by means of the arrow keys. Refer to ‘Data entry’
on page 27 . Press the Confirm key to store the data, or the Escape key to quit the
procedure without any changes.
Changing the maximum density (MaxD)
1
Perform steps 1 to 3 of the ‘Changing Image quality settings for a modality’
procedure on page 87 to select the modality and choose ‘Select other’.
The ‘Select for Modality’ screen is displayed:
2
In the ‘Select for Modality’ screen, press the Down key twice, followed by the
Confirm key to select ‘MaxD’.
The ‘MaxD (maximum density)’ screen is displayed:
All maximum densities are selectable starting from 2.80 to 3.40 in steps of 0.05
units. The activated setting is marked with a ‘*’.
"
The maximum density will be limited to the maximum density of the media.
3
Press the up/down key to select the desired maximum density setting for this
modality.
4
Press the Confirm key to store the data, or the Escape key to quit the
procedure without any changes.
CS
Enter smoothing
parameter:
advised value = 0.35
range [0.1-10]
enter absolute value
y.yy
CS
Select for
Modality16char:
1 Look-up table
2 Interpolation
3 MaxD
CS
Select MaxD for
Modality16char:
2.80
2.85
...
* 3.10
3.15
...
3.40