AGFA Drystar 5300, Reference Manual

Page: 182 / 210

182
2920B EN 20031206
Film identification problems
When you load a new film pack, the new Film Identification tag is read and
the tray film format and type are set based upon the info in the Film
Identification tag (RF-tag).
This tag is only readable when the film pack is inserted in the correct way.
The Film Identification tag is not readable
If the Film Identification tag of the film pack is unreadable, the user is asked to
reload the current or another film pack.
1
In case the Drystar 5300 does not start printing after re-inserting a film pack,
first check if this film pack is inserted correctly.
If the Drystar 5300 still does not resume printing, the following message will appear:
2
Open the input tray and check again if the film pack is inserted correctly. If
you re-insert the film pack, the Drystar 5300 will perform the same check-
sequence until printing is resumed.
Overruling the Film Identification tag of the film pack
If the “Overrule RF-tag Reading” setting is active, you can overrule the Film
Identification tag setting of the current film pack. In this case you can continue
printing using a limited Maximum Density.
"
Only your local service organization has the possibility to enable the
“Overrule RF-tag Reading” setting!
1
In case the Drystar 5300 does not start printing after inserting a new film
pack, check if this film pack is inserted correctly.
No Identification
code detected for
current film pack
Remove and re-insert
film pack -including
protective sheet-
properly. Follow
loading instructions