AGCO MASSEY FERGUSON 7380 CENTORA Combine Series, Workshop Manual

Page: 38 / 41

38 MF7380 - MF7382 CENTORA - EAME
D3117800M2 - S/N 582 582 583 583400001
1
1. Introduction - Specifications
Crop_this_page
1.5 Start-up instructions
1.5.1 General
T008020
To ensure that the machine is maintained regularly during the warranty period, head office or the local AGCO
dealer and supplier must arrange for a service inspection after 50 hours of operation and after the first har-
vest.
This inspection has been introduced and is designed to ensure that the machine gives optimum performance
throughout the warranty period, with the result that it will operate reliably for many years to come.
1.5.2 Pre-delivery checks
T019993
Prior to delivery to the dealer and delivery from the dealer to the customer or transfer to the user, head office
must ensure that the following is done:
BEFORE INSPECTION
– Check the combine/cutting table/table trailer and equipment for transport damage.
– Check that the combine has been delivered in accordance with the order/delivery specification.
– Verify and register the serial numbers on the combine, engine and cutting table.
– Fit any parts that were removed before transport.
– Fit any optional equipment ordered (if it was not fitted at the factory).
FLUID LEVEL CHECK
Check the various fluid levels and top up if necessary:
1. Cooling system, antifreeze 50%
2. Fuel tank.
3. DEF tank
4. Engine oil.
5. Gearbox.
6. Final drives.
7. Right-angle gear for unloading auger transmission.
8. Hydraulic oil tank
9. Brake fluid tank.
10. Wobble box (knife drive).
11. Right-angle gear for returns thresher.
12. Battery acid level and cable shoe.
LUBRICATION
Lubricate the following points:
13. All grease nipples.
SETTINGS
Fit the cutting table in accordance with the operator’s manual. Check and adjust if necessary:
14. Main crop elevator/chains.
15. Check tightening of all air-intake hoses/pipe connections on the engine.
16. Make sure that hoses, pipes and lines are not close to the exhaust system, belt pulleys, belts, etc.
17. Check the tightening of hoses and connections in the cooling system.
18. Check that the friction clutches for the table auger and main crop elevator do not slip, after dismantling
and cleaning.
19. Concave setting.
20. Rotary separator concave setting.
21. Rear beater curtains.