AGCO Massey Ferguson 1547, Service Manual

Page: 32 / 51

4283094M2 02-1
Cooling System
COOLING SYSTEM
RADIATOR LOCATION
m
CAUTION: DO NOT remove radiator cap
when engine is hot. Rotate cap slowly to
release pressure. Then cap can be safely
removed.
FIG. 1: Cooling system is filled at factory with anti-freeze
solution to protect engine and radiator to -34 degrees C
(-29 degrees F). Cooling level must be maintained to 12
mm (0.50 in) below the filler neck opening (1).
Make sure the radiator, radiator screen and grill screens
are clean to permit maximum cooling. Use compressed
air or water to clean, but use care when cleaning the
radiator to prevent cooling fin damage.
FIG. 2: Drain cock (1) will drain coolant from cylinder
block and radiator. Drain cock is located on right side of
engine. Coolant must be replaced if the coolant becomes
contaminated with rust or sludge. Loosening radiator cap
will assist draining.
NOTE: Flush inside of radiator and engine block prior to
replacing coolant.
Check condition of hoses, belt and clamps and replace as
necessary.
FIG. 1
i-9694
1
FIG. 2
I3188
1