AGCO LELY ATTIS PT 130, Operator'S Manual

Page: 12 / 98

• Do not change the machine
• If it is necessary to replace parts, only use parts with manufacturer approval
• Make sure that all covers and guards are in position and locked when you complete maintenance work.
1.2.6 Safe operation
Read and understand the general safety instructions then:
• Before you start to work with the machine do a visual inspection
• Make sure that no changes occurred to the machine and no components are missing
• Make sure that there are no unusual noises or leaks during operation
• Only use the manufacturers instructions when you operate the machine
• Do not get on or into the machine when it is operating
• Make sure that stop the tractor engine and remove the key before you remove crop material from the
machine
• Protective gloves must be in use when you do work on the knife of the film cutter
• Do not go near the loader arm or bale tipper area while the machine is in operation
• Control the machine from the operators seat only. Do not transport other persons on the machine
• When the machine is in operation do not climb on parts of the machine
• On a slope always put bales in a position in which they cannot move down the slope
• Make sure that there are no people or animals in the danger zone during operation . This is important in
or near areas that are open to bystanders
• Keep a minimum distance of 3 m from electrical high-voltage lines
• All persons must stay a minimum of 20 m away from the tractor and machine when it is operating. Use
more precaution when you do work adjacent to bystanders
• Make sure that there are no objects in the field that can cause damage to the machine
• Do not put more than the maximum load on the machine
• Do not operate the machine with defective, removed or opened protective devices.
After operation
• Park the machine on flat, level, and stable ground
• Before you disconnect the machine from the tractor, make sure that:
- The wheel chocks are against the wheels
- The machine is in the correct position on the support foot
- Release the pressure of the hydraulic system before you disconnect the hydraulic hoses. Refer to
the tractor manual.
1.2.7 Fire prevention
• Fire can easily occur with the harvested crop! To prevent fire:
- Remove all crops that stayed on the machine.
• Fire can occur when the parts of the machine get too hot! To prevent this:
- Follow the lubrication instructions
- Make sure that there are no oil leaks
- If a part of the machine gets too hot: find and remove the cause.
• Electricity can cause fire:
- Keep the electrical systems of the tractor and the machine in a good condition
- Do not use the wiring on the machine for devices other than those installed by, or approved by, the
manufacturer
- Too much load on the electrical cables will cause heat.
• Do not smoke near the machine
• Keep the exhaust system of the tractor in a good condition
• Keep a fire extinguisher near to the machine.
GUID-990C8397-1962-46DD-ACB6-9540147F86F5 [V1]
GUID-C4B0A4FF-367D-49A4-9D8B-9153EB38C04E [V1]
1. Safety
12 Bale Wrapper
4820.LE.EN01