AGCO LELY ATTIS PT 130, Operator'S Manual

Page: 11 / 98

1.2.2 Safe driving
Read and understand the general safety instructions. Make sure that:
• You always obey your local road traffic regulations and the speed limits
• The machine is in the transport position
• All parts that move are locked
• The control panel and the hydraulic system of the tractor are off
• All the lamps on the machine operate correctly and are clean from dirt
• Examine the operation of the brakes before you start to drive. Do not drive with the machine if there is a
problem with the brakes
• Do not make sudden turns when on a slope
• Drive slower when on a down slope
• Do not disengage the clutch of the tractor or change gears on a slope.
1.2.3 Safe driving on hillsides
• Only persons with approval for wrapping on slopes can operate the machine. To stop the machine from
tipping or overturning make sure that you monitor carefully when you work on a slope (for example
mountain areas, hills, ditches).
• Always use an applicable tractor for working on hillsides.
1.2.4 Public road transport safety
Read and understand the general safety instructions before you drive on the road. When you drive on the
road:
• Obey the local road traffic laws
• Keep a safe distance from other traffic
• Make sure that the lamps operate correctly
• Use warning lamps or other safety signs, if necessary
• If necessary by local law install the rear marking plate for Slow Moving Vehicles (SMV) on to the
machine
• If necessary by local law install the licence plate on the machine
• If necessary by local law, install the safety chains. Connect them to a rigid part of the tractor
• Remove loose objects that can fall off the machine, for example, loose crops, mud or soil
• Make sure that only approved tyre types are in use on the machine. Tyres not approved by the
manufacturer can be dangerous. Examine the transport wheels nuts and tighten them if necessary after
the set working hours or driven distance. Make sure that the tyres have the correct pressure. Do not
inflate the tyres with more than the recommended quantity of air
• Do not operate hydraulic components
• Make sure that the maximum height of the machine is safe when you drive below electrical lines and
structures
• Always keep a minimum distance of 3 m between the machine and electrical power cables
1.2.5 Safe maintenance
Read and understand the general safety instructions then:
• Before you do maintenance or do work on the machine:
- Stop the tractor engine and remove the key
- Stop all the parts that can move
- Put the wheel chocks against one of the wheels
• Do not touch parts that can move
• Obey the maintenance schedule in the manual to prevent problems
GUID-C35A84AB-7494-4739-ABC9-19396267E17D [V1]
GUID-997B6FB2-2B63-4A8D-8095-55DEAFE3A2F7 [V1]
GUID-90F7AF87-3EE3-4079-85DF-D4B288796E56 [V1]
GUID-107C5366-CF09-4D76-A61B-5357F8EE197B [V1]
1. Safety
Bale Wrapper 11
4820.LE.EN01