AGCO Combine CEREA 7274, Operator'S Manual

Page: 24 / 31

2. Safety
22
Combine Operator's Manual MF 7274-7278 CEREA Range - EN_D3110100M10
2.4 Road Transport
It is the responsibility of the owner/user that cutting table
and machine are fitted with the equipment required in the
country and driven according to the regulations in force
for road transport.
1. Safety guards, traffic lights, rotating beacon, reflec-
tors, warning triangle must be fitted and in transport
position.
2. Brake, steering gear, and other safety equipment
must comply with the relevant statutory require-
ments.
3. Rules governing maximum width, length, height and
total weight must be observed.
4. Rules governing driver's licence and insurance must
be observed.
5. Table and table trailer must be attached and secured
according to regulations.
6. In transport the forward speed of the machine must
not exceed the speed limit prescribed by law, irre-
spective of the conditions.
Note: To avoid accidents, all persons engaged in opera-
tion, maintenance, repair and testing of this machine
should familiarise themselves with the recommendations
and warnings in this operator's manual. The sections,
Safety Precautions and Before Start , are particularly
important.
Please also note:
If the combine is equipped with maize header or other
special header, the rules in force on the use and transport
of such headers must be observed.
The use of spare parts, accessories and additional imple-
ments which are not genuine and not tested and
approved by the manufacturer may cause changes in
machine function and thus affect work and road safety
(safety guards).
The manufacturer accepts no liability for any loss or dam-
age which may result from the use of non-original parts,
accessories or implements.
Technical specifications, dimensions and weights are
without any obligation.
Right to change technical specifications and equipment
reserved.
Front, rear, RH and LH are always seen in the travelling
direction.