62
Delete
If a Profile is no longer necessary, it can be deleted from the
Select Profile list. Follow the procedure below to delete a Profile.
1.
From the GPS tab, press the NTRIP button.
2.
Press the Blue Up/Down Arrows or directly select Profile
from the list on the right.
3.
Select the Profile to be deleted from the Select Profile list
on the left.
4.
Press the Delete button.
5.
Press the Green Check Mark to confirm deleting the Profile
or press the Red X to cancel deleting.
6.
The Profile will no longer appear in the Select Profile list.
GENERAL (AFTER PROFILE CREATED)
After the profile(s) have been created, the General tab will remember the last profile used. The operator can go to this
screen and manually Connect and Disconnect the NTRIP profile when needed. The system also has a NTRIP Auto-Connect
feature.
Connect
Follow the procedure below to connect to the last selected NTRIP server.
1.
From the GPS tab, press the NTRIP button.
2.
Press the Blue Up/Down Arrows or directly select General from the list on the right.
3.
Press the Connect button.
4.
If the system is able, it will then connect to the NTRIP stream.
Disconnect
Follow the procedure below to disconnect from the NTRIP
server.
1.
From the GPS tab, press the NTRIP button.
2.
Press the Blue Up/Down Arrows or directly select General
from the list on the right.
3.
Press the Disconnect button.
4.
The system will disconnect from the stream and will not
connect again until manually told to do so.
NTRIP Auto-Connect
The GeoSteer system has an NTRIP Auto-Connect feature. The system will automatically reconnect to the last NTRIP stream
shown in the General screen if:
•
The connection is lost due to the GeoSteer system being power cycled.
•
The data connection to the server is lost and then reestablished.