GeoSteer®
17
PN 2006410—ENG Rev. B
To start process, press Autocal button on
Manual Steering Override screen. Start
driving vehicle forward 2-5 mph (3-8 k/h) with
engine RPM at working level. Continue
driving and press
to start
calibration. Vehicle will first appear to do
nothing and then steering axle will make a
series of quick left and right small turns.
Once auto calibration has completed, Save
Calibration screen will appear.
Press
to save calibration and
continue to next step. Setup Wizard will
automatically start Auto Calibrate procedure.
Press the red X to cancel calibration, discard
values, and take user back to Manual Steering
Override screen.
÷
NOTE!: If Manual Steering Override is
not properly calibrated, system may
not disengage properly when
operator turns steering wheel. Never
operate an AutoSteered vehicle
without Manual Steering Override
properly set.
Flow Switch and Encoder Auto Calibrate
Some vehicle profiles use an encoder on the
steering wheel to detect motion at steering
wheel or a flow switch to detect change in flow
in the steering hydraulic lines. Encoders will send
a signal when the steering wheel is turned by
user. Flow switches will send a signal when it
detects oil flow through a hydraulic line. In either
case, there are only two states, on and off so
there is no adjustment required for these
sensors.
Information provided in this screen is:
Manual
Steering Override
—A green light indicates
AutoSteer system is detecting steering wheel
motion or flow at flow switch. A red light
indicates no motion or flow is detected.