Maintenance
EUROprinter II
9
9.3
Replacing Paper Roll
If the paper roll needs replacing, open the paper cup lid and remove
the spool and any remaining paper. Reel off a few centimetres from
a new roll of paper. Hold approximately 5cm of paper outside the
printer, place the new roll into the paper reservoir with the paper
feeding from the bottom front of the roll. with the leading edge over
the tear bar. Close the lid by applying equal amounts of pressure on
each side of the paper cup lid until the lid is in the locked position.
Which side of the thermal paper can be printed on?
Usually, the printable side of a thermal paper roll is on the outside.
See "Error detection and recovery".
Which thermal paper can be used?
The printer is specified for a paper width 57,0 ± 0,5 mm, a roll diame-
ter of 31 mm, a paper thickness of 60 g/m². Other papers might
cause failure.
Other paper:
Adhesive Labels are connected through perforation. There is a black
mark between the labels for correct positioning. This is the only type
of labels that can be printed with the EUROprinter.
10
Maintenance
After larger print efforts, depending on the paper quality and adverse
environmental conditions, it may be necessary to clean the print
head, sensor, and the platen roll, especially, if some areas are no
longer printed properly.
To protect the environment, batteries must not be disposed of
together with the normal household waste. Return old batteries
to the point of purchase or to a collecting point.
11
Shutting down and disposal
To protect the environment, this device must
not
be disposed of
together with the normal household waste. Dispose of the de-
vice according to the local conditions and directives.
