19
Mounting
EN
RG 210
5
Mounting
5.1
Preparing mounting
Verify that the product is mounted to an even, rigid and dry wall at eye
level.
Verify that the product is accessible and easy to oversee at all times.
Verify that the product is not exposed to water or splash water.
Do not install the product in damp rooms.
Verify that the ambient temperature at the product is not exceeded, see
chapter "Technical specifications").
Protect the product from direct atmospheric influences if it is installed out-
doors.
A properly operating system requires the tank to be equipped with an
overflow pipe or an overfill prevention system according to TRbF.
When the product is switched on and the probe is in air, the heat-up time
of the PTC thermistor is up to 15 seconds. This heat-up time must elapse
before the product is ready for operation.
When the PTC thermistor loses contact with a liquid, the heat-up time of
the PTC thermistor is approximately 30 seconds. This heat-up time must
elapse before the product switches.
Consider these response delays when selecting the height at which the
probe is to be mounted.
- When the PTC thermistor loses contact with a liquid, the heat-up time
of the PTC thermistor is approximately 30 seconds.
WARNING
HOT PROBE TIP
The probe tip can reach temperatures of more than 100°C.
•
Avoid any contact with the probe tip.
Failure to follow these instructions can result in death, serious injury or
equipment damage.
Summary of Contents for 53206
