R01.0
16/05/2019
Page 11
3.3
Requirements for the bowl
In order to achieve optimum transport behaviour, the following basic requirements must
be fulfilled:
1.
Combination bowl and WV must match each other
2.
Selection resistant construction of the bowl
3.
Control elements in the bowl must be oscillation resistant
3.4
Information for the construction of selection elements
Selection elements, which serve the sorting of the transported work pieces in the correct
orientation, must be of light but stable manufacture. The selection elements must be well
connected to the bowl so that no self-oscillations can occur which could cause possible
breakdowns.
The outlets must be as short as possible and must never run beyond the tangents of the
bowl. Constructional elements for outlet extensions must not be secured to the oscillating
system.
After the construction of selection elements, the oscillation system must always be re-
tuned to achieve an optimum conveying capacity.
Increasing of the conveying capacity by means of increasing the amplitude has an ex-
tremely negative effect on the system. Broken springs or inadmissible temperature in-
crease of the magnetic coil could be the result.
3.5
Power supply
WARNING
▪
Any work performed on the electrical supply may only be
performed by trained, authorised, qualified personnel!
▪
The power supply must be protected by an FI switch (pro-
vided by the customer).
▪
The bowl feeder may only be operated with the power sup-
ply specified on the name plate.
The control device1 IRG1-S is used for the activation of the bowl feeder. The MSG801 or
MSG802 can also be used. Please note that an additional CEE connector plug is required
for the MSG controllers (Order number 11006982)
Installation of the plug is only to be carried out by technically qualified personnel.
Figure 6:
End of the wire for additional plug
Summary of Contents for WV 630-1
Page 18: ...Page 18 16 05 2019 R01 0 ...
