Installation, assembly & setting
Assembly instructions EN
CR 25 / CR 32
Edition 01/2020
Rev. 4.0
39–56
Replacing the sensors
Proceed as follows to replace the sensors:
1. Loosen screw (Fig. 17, 2).
2. Remove the built-in sensor (Fig. 17, 1).
3. Assemble the new sensor as described in this chapter.
The sensor is replaced.
Fig. 17
Magnetic field sensor (example illustration)
6.2.5 Mounting of additional modules
Observe the indicated payloads when mounting additional modules (
Chapter
3 Technical Data).
Fig. 18
Mounting of additional modules
Afag assumes no liability for the integration of modules from other
manufacturers on the CR 25 / CR 32 rotary modules.
Make sure that the modules to be integrated are designed for the payload
generated during full operation of the rotary modules CR 25/CR 32.
1
2
