Afag 50386049, Assembly And Operating Instructions Manual

Page: 34 / 48

Fault elimination
34 – 48 Assembly instructions EN

CS 6/20 - CS 6/40

Date 01.06.2021

Version 2.0
8 Fault elimination
8.1 General notes
This chapter contains general information and safety instructions for
troubleshooting on the compact slide.
8.2 Safety instructions for troubleshooting
Also observe the safety instructions in

Chapter 2 „Safety instructions“ in
this manual.
8.3 Table fault causes and remedy
The following table contains an overview of possible fault causes and how to
proceed to eliminate them. Defective components must be replaced exclusively
by Afag original spare parts.
Fault Possible cause Remedy:
The compact slide strikes
firmly in the end positions

Stop/shock absorber not set
correctly

Readjust stop/shock absorber
Firmly strike again in the end
positions

Damping elements defective

Replace damping elements
(

Chapter 5.3 „Accessories")
The compact slide stops in an
end position

No signal on the proximity switch
/ sensor

Readjust proximity switch / sensor
The CS module stops again in
the end position

Sensor defective

Replace sensor (

Chapter 5.3
„Accessories")
WARNING
Danger of injury due to improper work!
Poorly performed troubleshooting work can lead to serious injuries and
damage to property.

The due diligence obligations of the user include ensuring that the
personnel working on eliminating faults appropriately trained and qualified.