Page 14
07/01/2021
R02.1
4.2.1
Addendum
Table 3:
Addendum
Symbol
Meaning
button to program, i.e. to change the value of a parameter the sys-
tem must be changed into programming mode. By pushing this
button one time, the system is prompted to allow changes. Some
areas of the parameters are protected with a CODE and require
further input.
Button to save, i.e. after changing the
values of parameters and wishing to permanently save this new
values (also after net ON/OFF) the button has to be pressed once.
. After pushing this button the word SAVE briefly appears in the
display for confirmation and
disappears again.
The operation and setting of the device is controlled with 8 keys that are located to-
gether with an LED display in a control panel on the front panel.
All parameter settings
can be made through this panel.
By using the value keys by briefly pressing the display
of one digit (or tenths or letter) is increased / decreased / changed. Keeping the keys
pressed, the system switches to continuous operation and after 3 seconds in fast mode,
ie automatically increase / decrease the values / change at different speeds.
If you push
the button for a longer time, the Control Element changed in permanent- or after 3
seconds in the fast mode
. It means that the values are automatically updated, re-
duced, modified with different speed.
To avoid some Accidental Release or unauthorized change, the machine settings are
locked via a CODE until the amplitude.
Changed data are not automatically stored. The Settings get cleared after 20 sec-
onds if there are no button movement.
If you change some data you must save it with this
button.
System message after net ON
As soon as that frequency-control-device switched on to the supply voltage and over
the power switch, the apparat reports after an initialization phase ready to operate.
For Example following messages are indicated on the 6-parts display:
System SIGA
Day, month and year of the compiling
