Mounting Instructions EN
◼
SE-Power FS
◼
01.06.2022
◼
V4.4
45
–50
7.2
Connecting the motor
▪
Plug the connector of the motor cable into the corresponding socket of the motor and
screw tight.
▪
Plug PHOENIX connector into socket
[X6]
of the device.
▪
Connect the PE line of the motor to the
PE
socket.
▪
Plug the connector of the encoder cable into the encoder output socket of the motor
and screw tight.
▪
Plug the D-Sub connector into the socket
[X2A] Resolver
or
[X2B] Encoder
of the
device and fasten the bolting screws.
▪
Connect the overall shield of the motor and encoder cable flat with the SK14 shield
clamp
▪
Check all connections again.
7.3
Connecting the servo positioning controller to the power supply
▪
Make sure that the power supply has been switched off.
▪
Plug the PHOENIX connector into socket
[X9]
of the device.
▪
Connect the PE line of the mains to the
PE
socket.
▪
Connect the 24V connections to a suitable power supply unit.
▪
Make mains supply connections.
▪
Check all connections again.
7.4
Connecting the PC (USB Interface)
▪
Plug the connector A of the USB interface cable into the socket for the USB interface
of the PC.
▪
Plug the connector B of the USB interface cable into the socket
[X19] USB
of the
servo positioning controller SE-Power FS.
▪
Check all connections again.
7.5
Connecting the PC (RS232 Interface)
▪
Plug the D-Sub connector of the serial interface cable into the socket for the serial
interface of the PC and fasten the bolting screws.
▪
Plug the D-Sub connector of the serial interface cable into the socket
[X5]
RS232/COM
of the servo positioning controller and fasten the bolting screws.
▪
Check all connections again.
