Managing the DataConference software
Data Conference is typically used when two ISDN, LAN, or NIC connected users decide to start a conference using T.120
communication.
Start the DataConf.exe program.
The program creates an automatic connection between the System and the PC. At this point, several items of information
concerning the connection are displayed:
•
The System IP address.
•
The network interface used for video calls.
•
The type of call: incoming or outgoing.
•
The T.120 data channel active.
•
The status of the NetMeeting connection between the two users.
Once the connection has been established, NetMeeting 3.xx is displayed in the foreground and you can perform all data
conference management operations.
If you desire to change the IP address of the System, you have to disconnect, press the key “Configure” and enter the new
address to use.
!
In the case of NIC conferences, it is necessary to configure one of the two users as Master by using the special
DataConf menu (in order to access DataConf menu click on
located at the top right of the graphic
displayed).
81
