100-240VAC
Industrial 4xFE PoE + 1xFE
EXPoE Switch
+ -
EX Mode
OFF
ON
1
2
3
4
5
PoE
LINK/ACT
PWR
VAC 100~240 power input
1. Install the PoE switch in a ventilated and dry place that is free of electromagnetic source, vibration, moisture, and dust.
2. Make sure the ventilation openings on the switch are not blocked.
3. Use CAT5 or 5e UTP/STP cables.
4. AC input (100~240V/AC, 50~60Hz)
5.
IP67 rated housing
6.
Although housing is IP67 rating , this is not suitable for water jets.
IMPORTANT
:
INTRODUCTION
LED DEFINITIONS
CONNECTION
* 1x PoE switch
* 1x Quick Installation Guide
* 1x T25 L-wrench
PACKAGE CONTENTS
Power
Orange ON
Power is on and normal.
Orange Off
Power is off.
Link/Act
Green ON
Ethernet port is connected.
Green Off
No connection.
Green blinking
Data is being transmitted or received.
PoE
Orange ON
Port is linked to a powered device.
Orange Off
No device is connected.
Orange blinking Abnormal power supply is detected.
H21-041-30-075
Quick Installation Guide
The H21-041-30-075 is a 4 port 10/100BaseT PoE switch capable of feeding 15.4/30W (54V max. per port)
power to
Power over Ethernet (PoE) devices. It comes with another 1x FE RJ45 uplink port.
Outdoor Unmanaged PoE Switch
Port LED1
Port LED2
EX MODE DIP SWITCH
EX ON
Ports 1 & 2 up to 250m PoE distance. When enabled, each port is isolated, but is linked to the uplink ports.
EX OFF
Normal communication for ports 1 ~ 5.
* EX mode in 802.3af (15.4W): camera connection up to 250m@10Mbps via EXPoE ports.
* EX mode in 802.3at (30W): camera connection up to 200m@10Mbps via EXPoE ports.
*Effect factors
1.Must connect af PoE PD.
2.Poor cabling quality with insufficient copper.
3.IP camera’s networking design could not support 10Mbps@250m transmission.
**Suggestion
1.Checking the interoperability reaching 10Mbps@250m before physical deployment.
2.Adjust to “EX Mode OFF” reaching 10/100Mbps@100m if “EX Mode ON” is fail.