ScoopTeam - User manual - Draft 0002
33
3.5. First level maintenance
3.5.1. Backup reset
This procedure should be applied to recover full control over the unit if it is in a status, in which it is not
possible to access all the functions (this might happen e.g. if the administrator’s password has been
lost).
After this reset, the ScoopTeam will be brought back to its “factory” configuration with all parameters in
their default value, especially: blank passwords, Ethernet interface set for auto link mode, DHCP client
enabled.
Go through the following steps:
TBC
Get the
reset_scoopteam.bin
file (to be downloaded from our
link can be found on the page dedicated to ScoopTeam).
Copy this file
without changing its name
on a USB memory stick.
Plug this stick into one of the USB host sockets on the rear panel of the unit (while it is off).
Power on the ScoopTeam.
After the initialization phase, ScoopTeam will go back to its “factory” settings.
Remove the USB stick (no matter with or without power on), before restarting the ScoopTeam,
otherwise all your possible new settings will be deleted again.
Note: existing profiles are not deleted by this procedure.
