Installation Manual
1) Before you install this equipment, please read this full manual.
2) Before screwing the camera unit to a wall or pillar, quickly connect
12v power to the camera unit, power up the monitor unit, and RANGE
TEST the system to check if it works at your required distance!
Installation
Wiring
3) As per Fig 1, plan the installation of the system.
Keep antennas high!
Mount at
eye level
Fig.1.
605A & AK
V2 (1200 keypad)
Entrance
Pillar
Antennas
House or
reception
area
Note: Wood and glass only reduce signal strength by 10-20%. Masonry will
reduce signal strength by 20-50% per wall. Metal can totally block signals.
For longer range
applications, locate
monitor handset near a
window at front of
property.
Up to
200m
1.2m
minimum
Installing the Speech Panel
Security Screws.
1) Unscrew both security screws, and the front door will hinge
downwards.
2) Drill a 20mm hole for the antenna cables and power wires.
3) Fit the intercom in place, lining up the rear access hole with the drilled
hole for the cables.
4) Use at least 10mm diameter, 50mm deep fixings to secure the
intercom to the wall. This will prevent it from being removed.
12v
dc in
N/C
N/O
Code
button
COM
+
-
Video
antenna
connection
Audio
antenna
connection
Relay output volt
free 4 sec pulse
Directional Video
antenna dish
Audio antenna
Note: Be sure to connect the correct
antenna to the matching antenna port
on the door station.
Do NOT cut antenna leads or attempt
to extend them.
Handset Functions
The handset comes with a Lithium Ion high quality mobile phone battery.
It is recommended to charge it for 8 hours before testing, to maximise
battery life.
Operation & Testing
1) Power up the door station and switch on the handset.
NOTE: You may need to wait up to 1 minute until the handset detects
the door station before you can test operation.
2) Press the call button on the door station. The handset should ring. If
it does not, try moving the handset to a different location and try again.
3) Check the screen which should show video images.
4) Answer the call, by pressing the OK button. You should be able to
hear and speak to the intercom from the handset.
5) While on the call, press to adjust the volume.
5) Press the door release button to activate the door or gates.
6) Press the OK button to end the call.
You will note that the video monitoring is designed to stay active for a
while even after the call has ended and the audio channels are closed.
Note: The handset should be held within 10-20cm of the person
speaking to achieve best volume performance. Speak into the top part
of the handset where the microphone is located.
If the handset is not answered within 40 seconds, the visitor will be
played a voicemail greeting by the door station, and they can leave a
voice message. In this case, after 1 minute a message symbol will
appear on the handset screen.
Note: The gates or door can be released from the handset even when
there is not a call active. Press and HOLD the release button for at
least 3 seconds to activate.
Microphone
Speaker
Video Screen
D Pad
Door / Gate Release button
Charging LED
Charging base
Monitor button
On/Off
Vibrate Switch
Code Button
OK
+
Keypad Connections
(ABK model)
-
12-24v
dc
N
/C
C
O
M
N
/O
N
/C
C
O
M
N
/O
e
g
re
s
s
OUT1 OUT2
OUT3
N/C
COM
N/O
K or A
DU out
(-)GND
Sense
O/P1 inhib
INT Lock
Tamper
N/C