40-7705ii-UM
Page 33
Rev. 1 June 11, 2018
6.1
Server Configuration
Among the first parameters that must be configured are on the Server
Configuration page. AES ships the receivers pre-configured as indicated
throughout this manual. To review or edit the parameters, access the Admin
GUI Server Configuration screen as indicated above and click on "Server
Configuration" on the left-hand side of the screen. This brings you to the AES
Server Configuration screen, where you modify as needed the following
parameters:
Figure 6-3 AES Server Configuration Screen
Server ID Number:
Identification number of your MultiNet Receiver (server).
Unless you are running more than one server at your site, we recommend using
the default value of 0001. Use 0002 for the second. Each needs a unique ID.
Range is decimal 0001 to 9999.
IP-Link Port Number:
Port used by your IP-Link Transceiver(s) to
connect to the server. Default and suggested value is 7070.
Modem Device Path:
Unix path used by the modem in your IP-Link
Transceiver. Default is “/dev/ttyS3”. Unless you are very well versed in Linux
and the hardware of this receiver, do not enter anything else here unless directed
by AES Technical or Engineering Support.
LCD Device Path:
Unix path used by the LCD in your IP-Link Transceiver.
Default is “/dev/ttyS2”.
