Aerpro AERA10
Radio Replacement Kit
for Jeep
Wrangler JL and Jeep Gladiator JT Vehicles
AMHJP2
K
Page 10
Section 4: In-Vehicle Harness Connections and Preparation
Step 1
If there are no open ports on the
CAN junction blocks, unplug one
factory male connector and insert
it into the same colored female
connector on the MQS4PT-36
harness, then insert the male
connector on the MQS4PT-36
harness into the now empty port
on the CAN junction block.
Behind the glovebox, connect
the male white connector from
the MQS4PT-36 harness into the
green CAN junction block and
the male green connector from
the MQS4PT-36 harness into the
white CAN junction block, then
run the 4-pin connector on the
MQS4PT-36 harness behind the
dash to the radio opening.
Part One: CAN Connections Harness (MQS4PT-36)
Step 1A
Part Two: GPS
& DAB+
Antenna and External Microphone (provided in
AERA10D
radio box)
Step 2
Step 1
Route the GPS
& DAB+
cable
s
down the
A-pillar past the plastic
dash
side panel, then route the
cable
s
behind the lower dash below
the steering column and then up the
center stack to the radio opening.
(Secure with zip ties along the way.)
DAB+
GPS
Clean the area next to the factory
antenna on the center roll cage
structure and stick the GPS
mounting plate to it. Then, secure
the GPS antenna to the mounting
plate (it is magnetic). Route the
cable behind the trim panels of
the roll cage over to the driver
side A-pillar.
Step 3
If you choose to use the external
microphone instead of the internal
microphone, mount it to the upper
windshield trim panel above the
rear-view mirror, then route the
cable underneath the trim panels
across the upper windshield and
follow the route of the GPS
& DAB+
cable
s
to the radio opening.
OR
Step 1B
