78
7. Insure the canopy is correctly installed into its
sliding track, shown below.
5. Slide the stab tubes in the fuse stab tube sleeves
(
short tube front, long tube rear
). Slide the
stabs on the stab tube and plug in the elevator
servo connectors. Secure elevator extension at
this time, us and Aeroworks safety clip to keep
the connector from
loosening in flight.
8. Tighten the 4-40 bolt securing the rear sliding
portion of the canopy.
6. Slide the rubber backed washers on the stab
mounting bolts and insert bolts through the stab
mounting tabs and into the fuse blind nuts.
Tighten snugly but do not over tighten and crack
the stab mounting tabs or the fuse sides.
If you do not remove your stabs for transportation
purposes. We recommend you use (blue) Loctite to
help keep bolts from vibrating loose.
We recommend checking the stab
mounting bolts after each flying
session
