XC2 Hardware Manual
Chapter 5: Maintenance
Chapter 5: Maintenance
DANGER
: Before you open the XC2 chassis, you must disconnect the Mains power connection.
DANGER
: All tests must be done by an approved service technician. Voltages inside the
controller and at the input and output power connections can kill you.
5.1. Preventative Maintenance
Do an inspection of the XC2 and the external wiring one time each month. It might be necessary to do more
frequent inspections based on:
l
The operating conditions of the system.
l
How you use the system.
Table 5-1:
Preventative Maintenance
Check
Action to be Taken
Examine the chassis for hardware and parts that are
damaged or loose.
It is not necessary to do an internal inspection
unless you think internal damage occurred.
Repair all damaged parts.
Do an inspection of the cooling vents.
Remove all material that collected in the vents.
Examine the work area to make sure there are no
fluids and no electrically conductive materials.
Do not let fluids and electrically conductive material
go into the XC2.
Examine all cables and connections to make sure
they are correct.
Make sure that all connections are correctly
attached and not loose.
Replace cables that are worn.
Replace all broken connectors.
Cleaning
DANGER
: Before you clean the XC2, disconnect the electrical power from the drive.
Use a clean, dry, soft cloth to clean the chassis of the XC2. If necessary, you can use a cloth that is moist
with water or isopropyl alcohol. If you use a moist cloth, make sure that moisture does not go into the XC2.
Also make sure that it does not go onto the outer connectors and components.
Do not use fluids and sprays to clean the XC2 because they can easily go into the chassis or onto the outer
connectors and components. If a cleaning solution goes into the XC2, internal contamination can cause
corrosion and electrical short circuits.
Do not clean the labels with a cleaning solution because it might remove the label information.
www.aerotech.com
77
