Chapter 3: -EB1 I/O Option Board
XC2 Hardware Manual
3.3.2. Analog Output [-EB1]
The analog output can be set from within a program or it can be configured to echo the state of select servo
loop nodes.
The analog output is set to zero when you power on the system or reset the drive.
Table 3-11:
Analog Output Specifications [-EB1]
Specification
Value
Output Voltage
-10 V to +10 V
Output Current
5 mA
Resolution (bits)
16 bits
Table 3-12:
Analog Output Pins on the Analog I/O Connector [-EB1]
Pin#
Description
In/Out/Bi
5
Ground
N/A
6
Analog Output 0
Output
Figure 3-7:
Analog Output Schematic [-EB1]
66
www.aerotech.com
