XC2 Hardware Manual
Safety Procedures and Warnings
Safety Procedures and Warnings
This manual tells you how to carefully and correctly use and operate the XC2. Read all parts of this manual
before you install or operate the XC2 or before you do maintenance to your system. To prevent injury to you
and damage to the equipment, obey the precautions in this manual. The precautions that follow apply when
you see a Danger or Warning symbol in this manual. If you do not obey these precautions, injury to you or
damage to the equipment can occur. If you do not understand the information in this manual, contact
Aerotech Global Technical Support.
This product has been designed for light industrial manufacturing or laboratory environments. The protection
provided by the equipment could be impaired if the product is used in a manner not specified by the
manufacturer.
NOTE:
All specifications and illustrations are for reference only and were complete and accurate as of the
release of this manual. To find the newest information about this product, refer to www.aerotech.com.
DANGER
: The voltage from this product can kill you. To decrease the risk of electrical shock,
injury, and death, you must obey the precautions that follow.
1. Obey the information in this manual.
2. Before you do maintenance to the equipment, disconnect the electrical power.
3. Wait at least one (1) minute after removing the power supply before doing maintenance or an
inspection. Otherwise, there is the danger of electric shock.
4. Before you connect wires to this product, disconnect the electrical power.
5. To decrease the risk of electrical shock and injury, you must supply operators with the
necessary precautions and protection from live electrical circuits.
6. While the drive is connected to a power source, do not connect or disconnect electrical
components and cables.
7. Make sure that all components are grounded correctly and that they obey the local electrical
safety requirements.
8. Make sure that you install the necessary precautions to supply safety and protection to the
operator.
9. Moving parts can cause crushing or shearing injuries. You must limit access to all motor and
stage parts while your system is connected to a power source.
WARNING
: To prevent damage to the equipment and decrease the risk of electrical shock, injury,
and death, you must obey the precautions that follow.
1. Obey the information in this manual.
2. Make sure that all system cables are correctly attached and positioned.
3. Use this product only in environments and operating conditions that are approved in this
manual.
4. Only operators who have received training can operate this equipment. All servicing and
maintenance must be done only by approved personnel.
www.aerotech.com
11
