Aerotech Soloist CP 10, Hardware Manual

Page: 26 / 112

26 Chapter 2 www.aerotech.com
2.1.1. Control Supply Connections (TB106)
N O T E : This product requires two power supply connections. The Motor Supply and Control Supply
must both be connected for proper operation.
The control power supply input allows the Soloist CP to maintain communications if the motor power is
removed, such as in an Emergency Stop condition. The control power supply requires a minimum of 85 VAC
input to operate properly. The AC1 input is internally fused. The AC2 input is not internally fused but can be
connected to a voltage source other than Neutral if an external 2 A time-delay fuse is used.
Although the control power supply contains an internal filter, an additional external filter located as close as
possible to the Soloist CP may be required for CE compliance (Aerotech recommends Schaffner FN2080 or
Aerotech UFM-ST).
Figure 2-1: Control Supply Connections
Table 2-1: Control Supply AC Input Wiring
Pin Description
Recommended Wire Size
(1)
AC1 Line (L): 85-240 VAC Control Power Input
0.8 mm
2
(#18 AWG)
AC2 Neutral (0V) or 85-240 VAC Control Power Input with external fuse
0.8 mm
2
(#18 AWG)
Protective Ground (Required for Safety)
0.8 mm
2
(#18 AWG)
(1) Refer to local electrical safety requirements to correctly size external system wires.
Table 2-2: Mating Connector Part Numbers for the Control Supply Connector
Type Aerotech P/N Phoenix P/N
Screw Torque
Value: Nm
Wire Size:
mm
2
[AWG ]
3-Pin Terminal Block ECK00213 1754465 0.5 - 0.6 3.3 - 0.516 [12-30]
Soloist CP Installation and Configuration