Aerotech Automation1 XC6e Series, Hardware Manual

Page: 90 / 110

Isolated Signals
This output signal is a fully-isolated 5-24V compatible output capable of sourcing or sinking current.
This output is normally open and only conducts current when a PSO fire event occurs.
The PSO Isolated Outputs are overload protected and will turn off if the maximum output current is
exceeded.
Figure 3-10: PSO Output Sources Current Figure 3-11: PSO Output Sinks Current
TTL Signals
This output signal is a 5V TTL signal which is used to drive an opto coupler or general purpose TTL
input. This signal is active high and is driven to 5V when a PSO fire event occurs.
Figure 3-12: PSO TTL Outputs Schematic
3.5. Position Synchronized Output Interface [-EB1] XC6e Hardware Manual
90 www.aerotech.com