Aerotech Automation1 iXR3, Hardware Manual

Page: 101 / 112

Appendix B: Voltage Selection Operation
DANGER : Disconnect Mains power before opening chassis. Voltage selector settings
must not be changed with Mains power applied to the unit.
DANGER : Wait at least ten (10) minutes after removing the power supply before
performing maintenance or an inspection. Otherwise, there is the danger of electric
shock.
WARNING : The voltage selector must be configured to match the AC line voltage and is
factory-configured based on the options that you ordered. You could damage the unit if
the voltage selector is set for the incorrect AC input voltage.
The voltage selector can only be used with transformer-derived bus voltages. This
voltage selector function should not be changed when using off-line supplies. Damage
to the unit may result if this function is used improperly.
If the user changes the voltage selector settings, it is also the user's responsibility to
change the iXR3/XR3 AC power label located next to the AC inlet. Refer to the
Section
1.1. for power ratings.
Procedure for setting AC voltage selector switches:
1. Turn-off and disconnect all power from unit.
2. Remove the four screws that secure the panel on the front of the iXR3/XR3
3. Carefully remove the panel without pulling out the wiring connected to the Power Switch.
4. Use
Table B-1 to set all of the voltage selector switches to the position indicated for the desired
operating voltage.
iXR3/XR3 Hardware Manual Appendix B: Voltage Selection Operation
www.aerotech.com 101