Aerotech Automation1 iXL2e, Hardware Manual

Page: 80 / 96

4.1. DIN Rail Mounting
DIN Rail Mounting Procedure:
1. Mount the DIN rail clip to the drive. The clip and #6-32 x 1/4 flat head screws are included in the
HyperWire-DIN clip kit.
2. Cut the DIN rail so that one complete mounting hole extends beyond the last component at each
end.
3. Secure the DIN Rail to the mounting surface with #10-32 screws spaced every six inches.
NOTE: Do not install the DIN rail to the mounting surface with the components already attached.
4. Install all components on to the DIN rail.
IMPORTANT : Refer to the Automation1 PS2 DIN Rail Power Supply hardware manual
for more information.
Table 4-2: Mounting Parts
Aerotech P/N
DIN Rail EAM00914
DIN Rail Clip Kit HyperWire-DIN
Figure 4-1: Din Rail Clip Dimensions
iXL2e/XL2e Hardware Manual
80 www.aerotech.com