Aerotech Automation1 iXL2e, Hardware Manual

Page: 48 / 96

2.3.6. Brake Outputs
The drive has a dedicated brake control circuit. Configure the brake with the BrakeSetup parameter
for automatic control (typical). You can also use software commands to directly control the brake
output.
Table 2-21: Brake Output Pins on the Feedback Connector
Pin # Description In/Out/Bi
13 Brake Output - Output
25 Brake Output
Table 2-22: Brake Control Specifications
Specification Value
Maximum Voltage 24 VDC
Maximum Current 1 A
A varistor must be connected across the brake to minimize voltage transients.
Figure 2-25: Brake Connected to the 25-Pin Feedback Connector (Typical)
iXL2e/XL2e Hardware Manual
48 www.aerotech.com