Aerotech A3200 Series, Hardware Manual

Page: 99 / 132

Options Npaq® Hardware Manual
3.5. Analog I/O Board Option [Archive]
N O T E : This option is no longer available for purchase. This section is for legacy users.
The Analog I/O board adds four 16-bit analog inputs and six 16-bit analog outputs to the Npaq. Both inputs
and outputs have a fixed range of ±10V and are updated at a 1 kHz rate. These ranges may not be exceeded
or damage may occur. It is not possible to change the input voltage range via parameters.
N O T E : The presence of the Analog I/O Board Option requires the use of several of the high-speed I/O.
When the analog I/O board is installed, the following I/O are no longer available for user I/O: HSOUT12,
HSOUT13, HSIN19, HSIN20, HSIO14, and HSIO15.
Table 3-6: Analog I/O Board Connector Pinout (J80)
Pin # Description In/Out/Bi Connector
1 Shield --
2 Analog Out 5 Output
3 Analog Out 7 Output
4 Analog Out 9 Output
5 Ground
Refer to Section
3.5.1.
6 +5V
7 Ground
8 +3.3V
9 Analog Input 6+ Input
10 Analog Input 7+ Input
11 Analog Input 4+ Input
12 Analog Input 5+ Input
13 Ground
Refer to Section
3.5.1.
14 Analog Out 4 Output
15 Analog Out 6 Output
16 Analog Out 8 Output
17 Ground
Refer to Section
3.5.1.
18 +12V
19 Ground
20 -12V
21 Ground
22 Analog Input 6- Input
23 Analog Input 7- Input
24 Analog Input 4- Input
25 Analog Input 5- Input
Table 3-7: Mating Connector Part Numbers for the Analog I/O Connector (J80)
Mating Connector Aerotech P/N Third Party P/N
25-Pin D-Connector ECK00101 FCI DB25P064TXLF
Backshell ECK00656 Amphenol 17E-1726-2
www.aerotech.com Chapter 3 99