Aerohive Networks Aerohive APs, Hardware Reference Manual

Page: 87 / 93

Chapter 8 The High Capacity HiveManager
86 Aerohive
7. From the front of the equipment rack, guide the chassis rails on the sides of the HiveManager into the inner
slides. Then push the HiveManager into the rack until the front mounting brackets are flush against the
front rack rails.
8. Using four screws—two for each of the front brackets—fasten the HiveManager to the equipment rack as
shown in Figure 6 . If the rack has round holes, use the two remaining bar nuts (and locator pins) and thread
the screws through the rack rails into them.
Figure 6 Mounting the HiveManager in an equipment rack
The HiveManager is now securely mounted to the front and rear rails of the equipment rack.
Rack rails
Rear
mounting
bracket
Outer slide
Inner slide
(over the
chassis rail)
Front
mounting
bracket
Screws