RN200 Mono Software User Manual
5
1.4
System Functions
The RN200’s system functions are shown in Table 1.
FUNCTION
TEST CASE
DESCRIPTION
Passive Test
Antenna pattern for 3/4
hemisphere
S21 amplitude and phase response
Active Non-
signaling Test
Tx test
Transmission antenna pattern, TRP, 3D
beam scan and spherical coverage,
spectrum test (OBW, SEM, ACLR) and
signal quality test (frequency error, LO
leakage, EVM, etc.)
Note: Tx signal can be a user-defined
arbitrary wave
Rx test
Receiving power level, receiving
sensitivity (DUT should support signal
demodulation)
Note: system receives arbitrary signal
from DUT, then upload data to PC for
data/algorithm analysis
RF Test
Spectrum analysis
Observe signal spectrum
Network analysis
S21 amplitude/phase response
Time domain analysis
Analyze time-domain signal from DUT
Others
Phased-array antenna
amplitude/ phase calibration.
Radar calibration, radar target
simulation
Upgradable
Table 1: The RN200 System Functions
