Aeroflex ProLock 2201, Getting Started Manual, Page: 35 / 60

Chapter 2 Installation
Configuring the software
2201 ProLock 15
Each device can be defined as follows by selecting the appro-
priate entries:
Your ProLock is now ready to start a test. Please refer to the 7310
Lector and Scriptor user’s guide on how to configure and carry
out tests.
Configuring the software
For a detailed description of the Software installation and config-
uration please refer to the 2201 ProLock User Guide.
Table 5 Transport input fields in the Connection menu
Transport
type
Parameters Remarks
USB/
RS-232 COM port
(range 1 – 99)
Baud rate (in kbps)
Handshake protocol
(Xon/Xoff, RTS, None) For RS-232 connections, use the
physical COM port number.
The RS-232 settings are irrelevant for
ProLock if you use a USB connection.
TCP/IP IP Address
Port The IP address must be selected in
line with the local area network poli-
cies. This must be the same address
as selected on ProLock. Each address
must exist only once within the net-
work.
The port number indicates the logical
port for the software.
Default port is 49200.
GPIB GPIB Address
(range 1 – 31) This should be identical with the GPIB
address of the instrument.
Default: 4.